Essential Information
- Bridge mode allows your Linksys Velop system to act as an access point, extending the range of your existing router without creating a separate network.
- Putting your Linksys Velop system in bridge mode is a straightforward process that can significantly enhance your home network.
- No, once you enable bridge mode, your Velop system will only function as an access point and cannot be used as a standalone router.
Bridging your Linksys Velop system to an existing router expands your network’s reach while maintaining a stable and efficient connection. Follow these detailed steps to seamlessly integrate your Velop devices into your home network.
What is Bridge Mode and When to Use It?
Bridge mode allows your Linksys Velop system to act as an access point, extending the range of your existing router without creating a separate network. This is ideal for situations where:
- You want to extend the Wi-Fi coverage of your existing router to a larger area
- You have a dead zone in your home that needs additional signal strength
- You need to connect devices to your existing network without assigning separate IP addresses
Prerequisites
Before you begin, ensure the following:
- Your Linksys Velop system is connected to the internet
- You have access to the Linksys app
- Your existing router is compatible with bridge mode
Step-by-Step Instructions
1. Connect Your Velop System to the Router
Connect one of your Velop nodes to your existing router using an Ethernet cable.
2. Open the Linksys App
Launch the Linksys app on your mobile device.
3. Select Your Velop System
Tap on the image of your Velop system to access its settings.
4. Go to Advanced Settings
Scroll down and tap on “Advanced Settings.”
5. Enable Bridge Mode
Under the “Bridge Mode” section, toggle the switch to “On.”
6. Confirm the Change
A confirmation message will appear. Tap “Yes” to enable bridge mode.
7. Reboot Your Velop System
Once bridge mode is enabled, reboot your Velop system by unplugging it from the power source and plugging it back in.
Troubleshooting Tips
If you encounter any issues while configuring bridge mode, try the following:
- Make sure your Velop system is connected to the internet.
- Ensure your existing router supports bridge mode.
- Reset your Velop system to factory settings and try again.
Benefits of Bridge Mode
- Extended Network Coverage: Expand the reach of your Wi-Fi signal to cover dead zones and improve connectivity throughout your home.
- Seamless Roaming: Devices can seamlessly roam between your existing router and Velop nodes without losing connection.
- Centralized Management: Control both your router and Velop system from a single interface using the Linksys app.
- Improved Performance: By eliminating the need for multiple networks, bridge mode can optimize network performance and reduce interference.
Wrap-Up: Bridging the Gap to Connectivity Bliss
Putting your Linksys Velop system in bridge mode is a straightforward process that can significantly enhance your home network. By following the steps outlined above, you can enjoy extended coverage, seamless roaming, and improved performance. Embrace the convenience and reliability of a bridged network and elevate your home connectivity experience.
Frequently Asked Questions
Q: Can I use bridge mode with any Linksys Velop system?
A: Yes, bridge mode is compatible with all Linksys Velop systems.
Q: Will I lose internet access when putting my Velop system in bridge mode?
A: No, bridge mode allows your Velop system to extend the range of your existing router without disrupting internet connectivity.
Q: Can I use my Velop system as a standalone router after enabling bridge mode?
A: No, once you enable bridge mode, your Velop system will only function as an access point and cannot be used as a standalone router.